contact us

Land Rover LR4

Placing Vehicle in Transport Mode & Removing From Transport Mode using Autologic's DrivePRO

 

In this video and article, the placing Land Rover LR4 in and out of Transport Mode using Autologic's DrivePRO is shown.

Begin by identifying the vehicle you are working on

Select Automatic Detection

Confirm vehicle information is correct

Select Ok

To place the vehicle in Transport Mode, begin by selecting Chassis

Select Ride Level Control (RLM)

Select Suspension Geometry Setup

Turn off the ignition and wait 5 seconds. Then turn on the ignition

Select Ok

Select SET next to Tight Tolerance Mode to switch the Control Tolerance Mode from NORMAL to TIGHT

Turn off the ignition and wait 5 seconds. Then turn on the ignition

Select Ok

Routine is complete. Select Ok

Vehicle is now in Transport Mode

To remove vehicle from Transport Mode:

From the Ride Level Control (RLM) menu, select Faults (DTC)

“U3000-05: Control Module – System Programming Failure” – fault set due to being put into Transport Mode

Select Clear and Re-Read fault codes

Fault is a hard code and will clear once taken out of Transport Mode

Select Back

Select Suspension Geometry Setup

Turn off the ignition and wait 5 seconds. Then, turn on the ignition

Select Ok

The Control Tolerance Mode is set to Tight. We will switch it to NORMAL by selecting Set next to Normal Tolerance Mode

Turn off the ignition and wait 5 seconds. Then, turn on the ignition

Select Ok

The routine is complete. Please read and clear faults after this procedure

Select Ok

Select Faults (DTC)

Select Clear and Re-Read

The system programming failure fault code is now cleared

Vehicle has been removed from Transport Mode